Resistive Matching and Attenuating pads.

Resistive Matching and Attenuating pads.

Post by Reg Edward » Sun, 07 May 2000 04:00:00

DESIGN OF MATCHING PADS & ATTENUATORS

New program MATCHPAD.exe calculates component values of T and Pi
attenuating and matching networks for any source and load resistances
and any attenuation up to 80 dB.  Special consideration for minimum
loss matching pads.

Download MATCHPAD in a few seconds from my website. Not zipped up. Run
immediately. User friendly. Has an educational content - sweep
attenuation over a wide range and watch resistor values change.
Compare T with Pi.
--
Regards,  Reg, G4FGQ
============================
Free radio design software from : -
http://www.btinternet.com/~g4fgq.regp
============================