AR800 and HP 200lx palmtop

AR800 and HP 200lx palmtop

Post by S. Sula » Mon, 25 Nov 1996 04:00:00

Has anyone successfully used an HP200lx palmtop to program their AR8000?
If so, what software program have you used and which connector from the HP
Connectivity pack have you used.  I have the  CAT232C serial interface and
have successfully programmed the AR8K with my desktop, but I cannot seem
to get the palmtop and the 8K to communicate with each other.  One
possibility is that the HP200lx does not supply enough power to the
CAT232C.  I am open to suggestions, thories, etc.

 
 
 

AR800 and HP 200lx palmtop

Post by Greg Gilber » Mon, 25 Nov 1996 04:00:00



> Has anyone successfully used an HP200lx palmtop to program their AR8000?
> If so, what software program have you used and which connector from the HP
> Connectivity pack have you used.  I have the  CAT232C serial interface and
> have successfully programmed the AR8K with my desktop, but I cannot seem
> to get the palmtop and the 8K to communicate with each other.  One
> possibility is that the HP200lx does not supply enough power to the
> CAT232C.  I am open to suggestions, thories, etc.

Hi,

Good luck!

:-) Greg

--

AOR 8000                  |   _____   /|\
AOR 7030                  |__/     \___|
                            (*)G G(*)
                                L
                               ~~~

 
 
 

AR800 and HP 200lx palmtop

Post by James F. Boehner, M » Mon, 25 Nov 1996 04:00:00


> Has anyone successfully used an HP200lx palmtop to program their AR8000?
> If so, what software program have you used and which connector from the HP
> Connectivity pack have you used.  I have the  CAT232C serial interface and
> have successfully programmed the AR8K with my desktop, but I cannot seem
> to get the palmtop and the 8K to communicate with each other.  One
> possibility is that the HP200lx does not supply enough power to the
> CAT232C.  I am open to suggestions, thories, etc.

I'm not sure if you're using Scancat Gold as the dos program, but if you
have the CAT-232 interface, I'm sure Jim Springer can help.  Contact him
at:


Hope this helps!

'73 de JIM N2ZZ

 
 
 

AR800 and HP 200lx palmtop

Post by Mik » Tue, 26 Nov 1996 04:00:00



Quote:

>Has anyone successfully used an HP200lx palmtop to program their AR8000?
>If so, what software program have you used and which connector from the HP
>Connectivity pack have you used.  I have the  CAT232C serial interface and
>have successfully programmed the AR8K with my desktop, but I cannot seem
>to get the palmtop and the 8K to communicate with each other.  One
>possibility is that the HP200lx does not supply enough power to the
>CAT232C.  I am open to suggestions, thories, etc.

Use a Null Modem Adaptor on the end of your HP serial connectivity kit cable,
then any software should work. If you're looking for simple. Check out my
program at http://www.ohio.net/~mwaldron . It's *SMALL* and does some basic
stuff.